We apologise that you received a front wooden bench with the logo in the wrong corner! Fortunately there is a quick and simple fix!
A suitable sized drill bit is included in the mounting kit used to drill holes for the black side hanging knobs. Holes can be drilling in the correct locations to mount the brackets around the right direction. Please review the steps below and contact us if any issues or further questions.
Step 1
- Flip board over front/back so logo is bottom right and underneath (facing the table).
Step 2
- Position the brackets in the correct direction, aligned with the existing holes.
- Align the vertical face of the bracket with the rear edge of the board (close to the grill).
- Mark three drill points with a marker pen through the holes in both brackets.
- Drill the marker points to half the board depth with the 2.5mm drill bit supplied in the mounting kit.
- Mount the brackets with the supplied screws as per online assembly instructions.
Step 3
- Make contact with us (if you haven’t already) and we’ll send out out one of our popular stainless steel stubby holders so you can enjoy a cold beverage along with our apologies!!
